2x4basics Deck-Bench Brackets, Sand (2-Pack)

Features

Set of 2 deck-bench brackets; used to build seating or a railing on patio

Sturdy plastic construction; stronger than steel; resists rust, rot, and cracks

Use only 7 inches of deck space; angled for extra comfort; assembly requires only basic tools

All hardware included; lumber for seating sold separately; 10-year warranty

Assembled bracket weighs 6 pounds; stands 36 inches tall with bench seat 17 inches above deck

Product Review
Maximize patio space while creating seating or a railing by installing deck bench brackets from 2x4basics. Using only 7 inches of deck space, users affix the brackets to a patio edge to expand their outdoor living space. Spacing the brackets 24 inches apart and adding lumber, ensures these brackets sturdily attach benches

Constructed in a special plastic stronger than steel, the brackets stand up to all degrees of weather while handling standard household regulation weight capacities. The comfortable angle and adaptable design enable users to suit their own needs, whether with a new or old deck or even a boat dock. The brackets work with most types of lumber for greater flexibility. Only basic tools are required for assembly and all hardware is included. For seating, 2x4basics recommends leaving 4 to 12 inches of space from the bracket to the bench end. 2x4basics does not recommend painting the brackets. A ten-year warranty is available for defective parts or craftsmanship for this product. The assembled bracket stands 36 inches high, while the bench seat sits at 17 inches above the deck. Upon shipping, this product measures 18.75 by 22.88 by 2.32 inches, and weighs 6 pounds. --Jessica Reuling

Product Description
Look, you can do it the hard way, or you can do it the SUPER EASY way! That's the story on using these Bench Brackets. Use 'em to make attractive deck benches that double as a 36" h. safety railing! Bench Brackets save you from planning the tough angles, cutting and assembling bench / railing supports you just add your own lumber and you're set. Here's the beauty: You get 2 Brackets, to be placed 20-24" apart, with 2 x 4's extending up to 12" from ends. So each bench set can be up to approx. 48" long; Made of high-density, all-weather structural polyethylene and rigid PVC for a strong, long life; All assembling hardware and complete instructions included; Efficient, using only 7" of deck space; The "DIY" design lets you make it any size to fit where and how you'd like; Each is 13 3/4" deep, 2 1/4" thick and 22 1/4" high. Weighs 4 1/2 lbs. Assembly requires just drill / driver, saw, tape measure and wrench. You'll be amazed by how fast, easy and well your deck is done! Figure your measurements then order yours ONLINE! Set of 2 Bench Brackets

Reader Reviews
I had about an 8' straight run to put a bench in, so used four brackets. Is was fairly quick (about 2-2.5 hours, I have a power miter saw), and instructions were clear. Once installed, there was too much "wobble" in the bench - front-to-back, not side-to-side. Luckily, I had posts on the end I could brace it to, so the end result is fine, if you don't have something to brace the ends to, I'd think twice. Lastly, the bench itself is not that comfortable (I find the seat too shallow). Also, the hardware is not the highest quality, and I anticipate it will rust rather quickly (I used stainless steel deck screws to fasten the back and lower front rails). Lastly, pay extra close attention to the washers you use - very similar OD, with a different ID made me redo about 5 screws (my fault, I know). I am and advanced DIYer (I built the 450 sqft three level deck the bench was for).

List Price: $44.99
Available from Amazon
Price: $29.99
Updated on 12-7-2008.